Dynamic Armature Balancing Machine With Belt Drive , DC Power Tool
Motor Balancing Machine
1. Model No.: ND-DH-5Z
2. This automatic positioning armature dynamic balancing machine
can find and stop at unbalanced position automatically. No need to
mark on armature (such as reflective sheet, black mark and so on).
3. This machine balance armature carries out the correction by
adding weight to the armature.
4. This machine can test armature imbalance automatically.
5. this machine can automatically do positioning for the armature.
6. PLC control.
This machine is suitable for Armature dynamic balancing (refer to
below machine's specifications). The correction way is adding
weight to the armature. It’s suitable for small armature. Machine
can be customized as per customer’s armature. The machine is widely
used in the motor field, such as wiper motor, vacuum cleaner motor,
mixer motor, window lifter motor, condenser motor, power tool
motor, DC motor, etc.
Armature lamination length
Armature diameter range
Automatic Positioning Armature Dynamic Balancing Machine Adding
This machine automatically measures the unbalancing amount of the
armature, automatically stops the armature at the unbalancing
position, then operator needs to stick the balancing mud onto the
unbalancing position manually. Operator doesn’t need to make any
mark on the armature(such as sticking reflective sheet, black mark,
1. Put in machining armature manually
2. Carry out armature's imbalance testing automatically (can start
by manual), display and maintain testing data automatically, at the
same time, it can display angular difference of left and right
imbalance point, simple and easy operation, furthest to avoid
faults during operation.
3. Stop at adding weight point (left) automatically, finish adding
manually, change to the next adding weight point(right), finish
adding manually, test again, and complete balancing adjustment.
4. Take out well-balanced armature, put in unbalanced one.
1. Professional testing machine box
2. High sensitivity hard support measure frame
Machine's efficiency of operations:
1. Relate to the initial imbalance volume the balancing volume of
2. Cycle of measurement is 6s/piece; usually measure 2-3 times.
1. No need to mark on the armature (such as reflective sheet, black
mark an so on)
2. Imbalance point positioning automatically
3. Low operation skill requirement to staff
4. Reduce the complexity of the machine operation
5. PLC control.